Differences

This shows you the differences between two versions of the page.

--- report:dvp [2026/05/28 00:24] – [Structure] team6
+++ report:dvp [2026/05/28 00:37] (current) – [Tests & Results] team6
@@ Line 656: / Line 656: @@
 == Hardware tests ==
-Perform the hardware tests specified in [[report:intro#tests|Tests]]. These results are usually presented in the form of tables with two columns: Functionality and Test Result (Pass/Fail).
+Perform the hardware tests specified in [[report:intro#tests|Tests]]. These results are presented below in the form of table {{ref>}} with three columns: ID, Functionality and Test Result (Pass/Fail).
+<table tests>
+^ ID ^ Functionality ^ Status ^
+| FT-GY01 | GY-21 Baseline Calibration Read | Pass |
+| FT-GY02 | GY-21 Thermal Responsiveness | Pass |
+| FT-GY03 | GY-21 Humidity Saturation | Pass |
+| PT-GY01 | GY-21 Environmental Recovery Rate | Pass |
+| PT-GY02 | GY-21 I2C Polling Stress (50ms) |  |
+| FT-BH01 | BH1750 Lux Range Verification | Pass |
+| FT-BH02 | BH1750 Shadow Transient Detection | Pass |
+| PT-BH01 | BH1750 Continuous Light Exposure | Pass |
+| PT-BH02 | BH1750 High-Freq Transitions (10Hz) |  |
+| FT-MQ01 | MQ-135 Analog Voltage Baseline | Pass |
+| FT-MQ02 | MQ-135 VOC Spike Detection | Pass |
+| PT-MQ01 | MQ-135 48h Thermal Burn-in Drift |  |
+| PT-MQ02 | MQ-135 Dissipation Latency | Pass |
+| FT-WA01 | Atomizer Digital State Actuation | Pass |
+| FT-WA02 | Atomizer Capillary Wicking Action | |
+| PT-WA01 | Atomizer 1000 Duty Cycles Endurance |  |
+| PT-WA02 | Atomizer Driver Board Thermal Load | |
+| FT-SYS01 | System I2C Address Multiplexing | Pass |
+| PT-SYS01 | Power Supply Rail Voltage Stability |  |
+| PT-SYS02 | System End-to-End Latency | Pass |
+</table>
 == Software tests ==