report:intro

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
report:intro [2026/06/03 12:29] – [Usability Testing] team6report:intro [2026/06/03 15:01] (current) – [Web Application Stress Testing] team6
Line 148: Line 148:
  
  
-As shown in Figure {{ref>fig:webapp_stresstest_results}}, the application processed 1,130 HTTP requests with a failure rate of 0.00%. All checks were completed successfully: 1,130 out of 1,130 checks were completed. The average response time was 34.21 ms, and the response time at the 95th percentile was 95 ms, which is well below the set limit of 2,000 ms.+As shown in Figure {{ref>fig:webapp_stresstest_results}}, the application processed 1,130 HTTP requests with a failure rate of 0.00 %. All checks were completed successfully: 1,130 out of 1,130 checks were completed. The average response time was 34.21 ms, and the response time at the 95th percentile was 95 ms, which is well below the set limit of 2,000 ms.
  
 These results demonstrate that the web application remained stable and responsive under the tested load. Since the test was limited to 5 virtual users, it should be considered an initial performance test rather than a full-scale stress test. These results demonstrate that the web application remained stable and responsive under the tested load. Since the test was limited to 5 virtual users, it should be considered an initial performance test rather than a full-scale stress test.
  • report/intro.1780486152.txt.gz
  • Last modified: 2026/06/03 12:29
  • by team6